Beaker Preparation

How to prepare Aptamil Follow On Milk

How to prepare a beaker

Our expert team are here to help.

Watch our guide on how to prepare a beaker correctly.

The Careline team

Important feeding instructions

  • Make up each feed as required
  • For hygiene reasons, do not store made up feeds and discard unfinished feeds as soon as possible, and always within 2 hours
  • Do not heat feeds in a microwave, hot spots may occur and cause scalding
  • Never add extra scoops or anything else to your baby’s feed
  • Never leave your baby alone during feeding

Because powdered milks are not sterile, failure to follow instructions may make your baby ill.

Wash hands and sterilise all utensils according to manufacturers’ instructions.

Boil 1 litre of fresh water. Leave kettle to cool for 30 minutes and no longer (allowing the water to reach 70°C once cooled from boiling). Measure the required amount of water (refer to the feeding guide) into a sterilised bottle. Be careful of scalding. Do not use artificially softened or repeatedly boiled water.

Using the scoop provided, level off the powder with the built in leveller. Do not press/heap the powder.

Add the correct measure of powder to the water. This can be found in the feeding guide on the back of the pack. Adding too many or too few scoops can be harmful. Shake vigorously and vertically for 10 seconds until the powder is dissolved. Rolling the bottle or shaking in circles will not be sufficient.

Cool under running tap. Check temperature of feed. Feed immediately.

It’s important to be careful with the water you use to prepare a formula feed if your normal drinking water supply is either interrupted or contaminated. Follow these Food Standards Agency guidelines to make sure you prepare the baby formula safely.

Step 1

Use bottled water or water from a bowser (a water tank provided by water companies) and bring it to a rolling boil. Leave it covered to cool for no more than half an hour.

Step 2

If there’s no electricity or gas to boil with, bottled table, spring or mineral water can be used and the prepared feed should be used immediately. The use of unboiled bowser water should be avoided.

Step 3

Some bottled water labelled as ‘natural mineral water’ may have high levels of sodium or sulphate. Read the label carefully and check that the figure for sodium (Na) is not higher than 200mg per litre and sulphate (SO or SO4) is not higher than 250mg per litre. If it is, then try to use another water. If no other water is available, then use this water for as short a time as possible.

Step 4

Follow the normal instructions for making up the feed.

Please follow these instructions carefully. Failure to follow instructions may make your baby ill.

Step 1

Wash hands and sterilise all utensils according to manufacturers’ instructions.

Step 2

Shake bottle well. Pour the required amount into a sterilised feeding bottle.

Step 3

Aptamil Follow On Milk can be given at room temperature, or warmed if desired. If warmed, check temperature of feed.

Step 4

For hygiene reasons, discard unfinished milk in the feeding beaker as soon as possible, always within 2 hours.

Questions about feeding and nutrition?

Our midwives, nutritionists and feeding advisors are always on hand to talk about feeding your baby. So if you have a question, just get in touch.

More from our experts

Quality, assured

We are devoted to providing you & your baby our very best.
Our Nutricia factories don’t produce for any supermarket own label or own brand products.

Find out more about our commitments to high quality

Important notice

Breastfeeding is best for babies. Follow-on milk is only for babies over 6 months, as part of a mixed diet. It should not be used as a breastmilk substitute before 6 months. The decision to start weaning including the use of this product before 6 months should be made only on the advice of a doctor, midwife, health visitor, public health nurse, dietitian, pharmacist, or other professional responsible for maternal and child care, based on baby’s individual needs.