Important feeding instructions

  • Make up each feed as required
  • For hygiene reasons, do not store made up feeds and discard unfinished feeds as soon as possible, and always within 2 hours
  • Do not heat feeds in a microwave, hot spots may occur and cause scalding
  • Never add extra scoops or anything else to your baby’s feed
  • Never leave your baby alone during feeding

How to prepare Aptamil Follow On milk

Because powdered milks are not sterile, failure to follow instructions may make your baby ill.

Step one Feeding instructions

Step 1

Wash hands and sterilise all utensils according to manufacturers’ instructions.

Step two Feeding instructions

Step 2

Boil 1 litre of fresh water. Leave kettle to cool for no longer than 30 mins. Measure the required amount of water (refer to the feeding guide on the side of the pack) into a sterilised beaker. Be careful of scalding. Do not use artificially softened or repeatedly boiled water.

Step three Feeding instructions

Step 3

Using the scoop provided, level off the powder with the built in leveller. Do not press/heap the powder.

Step four Feeding instructions

Step 4

Add the correct measure of powder to the water. Adding too many or too few scoops can be harmful. Shake well (for 10 seconds) to dissolve the powder. Replace the lid on the beaker.

step 5

Step 5

Cool under running tap. Check temperature of feed. Feed immediately.

How to prepare a powdered beakerfeed without tap water

It’s important to be careful with the water you use to prepare a formula feed if your normal drinking water supply is either interrupted or contaminated. Follow these Food Standards Agency guidelines to make sure you prepare the baby formula safely.

Step 1

Use bottled water or water from a bowser (a water tank provided by water companies) and bring it to a rolling boil. Leave it covered to cool for no more than half an hour.

Step 2

If there’s no electricity or gas to boil with, bottled table, spring or mineral water can be used and the prepared feed should be used immediately. The use of unboiled bowser water should be avoided.

Step 3

Some bottled water labelled as ‘natural mineral water’ may have high levels of sodium or sulphate. Read the label carefully and check that the figure for sodium (Na) is not higher than 200mg per litre and sulphate (SO or SO4) is not higher than 250mg per litre. If it is, then try to use another water. If no other water is available, then use this water for as short a time as possible.

Step 4

Follow the normal instructions for making up the feed.

How to prepare our liquid milk

Please follow these instructions carefully. Failure to follow instructions may make your baby ill.

Step 1

Wash hands and sterilise all utensils according to manufacturers’ instructions.

Step 2

Shake the bottle of Aptamil Follow On milk before opening. Using the feeding guide, pour the required amount of infant milk into a sterilised feeding beaker.

Step 3

Aptamil Follow On milk can be given at room temperature, or warmed if desired. If warmed, check temperature of feed.

Step 4

For hygiene reasons, discard unfinished milk in the feeding beaker as soon as possible, always within 2 hours.